PLA Recycling Drop-Off
Forgely recycles PLA. Bring your failed prints, misprints, purge scraps, and empty spools to our Roy or Murray, Utah store, a free way to keep PLA out of the landfill.
Forgely recycles PLA. Drop off failed prints, misprints, purge scraps, and empty spools at our Roy and Murray, Utah stores during open hours, a free way to keep PLA out of the landfill.
Bag it, bring it, we recycle it
1. Bag your PLA scrap
Collect failed prints, misprints, purge lines, support scraps, and empty spools, keep it PLA and reasonably clean.
2. Bring it to a store
Drop it off at either Forgely store during open hours. No appointment needed, just hand it to the team.
3. We keep it out of the trash
We collect the PLA for recycling instead of the landfill. It’s a free service, no purchase required.
PLA scrap, out of the landfill
Instead of tossing failed prints, misprints, and purge scraps in the trash, bring your PLA back to a Forgely store. We collect it for recycling, a small, local way to cut down on 3D printing waste.
Ask in store which PLA we can take, accepted brands are confirmed at the counter.
- Failed prints & misprints
- Purge lines & support scraps
- Empty filament spools
- Drop off at Roy or Murray
- Accepted PLA confirmed in store
A community service, not a buyback
PLA drop-off is free, there’s no charge to bring it in and no purchase required. It’s part of keeping 3D printing local and low-waste here in Utah.
We recycle PLA specifically. Not sure whether something qualifies? Bring it in and ask, or send us a note first using the form below.
- Free drop-off, no purchase needed
- PLA only
- Ask in store for specifics
Where to bring it
Forgely Roy
Utah's 3D Printing Destination
- 5519 S 1900 W, Roy, UT 84067
- 385-449-2694
- Mon–Fri 10–8, Sat 10–6
Forgely Murray
Salt Lake's 3D Printing Destination
- 6212 State St, Murray, UT 84107
- 385-446-1860
- Mon–Fri 11–6, Sat 11–3
Questions about PLA recycling
Bring in your PLA
Drop off failed prints, misprints, and empty spools at our Roy and Murray, Utah stores, free. Questions first? Send us a note below.
Ask before you haul it in
Not sure whether your PLA qualifies, or which store to bring it to? Tell us what you've got and we'll get back to you — or just bring it in during open hours.
Want your print featured instead? Submit it to the maker gallery